Teac LCDV1955HD - Connecting to an External AV Signal Source; Connecting an External AV Signal Source (YPbPr)

- -
13
System Connections
Connecting to an External AV Signal Source
Use the AV cables to connect the external AV signal source to the AV input jacks on the rear panel
of the unit. Use a S-VIDEO cable (not supplied) to connect the external AV signal source to the
S-VIDEO input jack on the rear panel of the unit.
After connection, turn on the power of the unit and the external AV signal source. Press INPUT
then direction buttons to select COMPOSITE or S-Video mode, and then press the
ENTER button to
confirm.
¾ The L/R audio input jacks can be used in both
AV and S-VIDEO modes.
Connecting an External AV Signal Source (YPbPr)
Use AV cables to connect an external AV signal source to the Y/Pb /Pr (Component) input jacks on
the rear panel of the unit.
After connection, turn on the power of the unit and the external AV signal source. Press INPUT
then direction buttons to select Compo
nent mode, and then press the ENTER button to confirm.