User frequency
In the Main overview, you can switch from the standard band selection to a manual selected frequency. To
do so, select any channel in the
Main
menu and hold down the joystick for about 2 sec till the sub-menu
shows up. In there select
Custom Freq.
Now you can set the frequency with
Up
and
Down
. If The selected
frequency does not match with any of the standard bands, it will show
US XXX .
When you leave the
channel, your User Frequency is gone. If you want to use it more than once, add it as a
Favorite
.
A user frequency can also be set as favorite like any other channel.
Autolock
Let the Fusion search for a strong signal. Up/Down to search for the next signal. When a strong signal is
found, the Fusion will tune in to this channel and return to the live feed.
OLED + OSD
● Actual Channel: the channel the Fusion is scanning right now
● Progress Bar: Scan status over the entire 5.8 band
To Next Page
Loading...