Agent X menu work as well:
● Power up your Fusion and connect it by USB to your Agent X
● Navigate in the Fusion menu to
WiFI/ General
● Hit
Scan
to search for available networks
● Under
SSID
you can select the found network
● Enter password for the selected WiFI hotspot/ network in
Password
option
● Select
Connect
to start the manual connection to the selected WiFI hotspot/ network
● Done
Direct Crossfire/ Tracer connection
You can connect your Fusion module directly to the WiFi access point of your TBS Crossfire. This short
connection unlocks the needed speed to get features like Dynamic Vtx power or the real-time telemetry
based OSD running smooth. Details for this features can be found in the following chapters
Connecting your Fusion to the Crossfire is an easy job:
● Power up your Crossfire by a radio
● Power up your Fusion module
● Make sure the WiFi of the Crossfire and the Fusion is turned on
● Navigate in your Fusion to
Settings/ CRSF/ Fusion WiFi/ General
● Search for networks and then select the Crossfire WiFi module
○ No password is needed unless you enabled one in the Crossfire WiFi module
● Hit
Connect
and wait for the message to disappear
When you power up your devices, the Fusion OSD and OLED will show no VTx related data as they need to
sync up at the beginning. This can take up to 30s.