EasyManua.ls Logo

TECALEMIT FMT 3 - Personnel and Operational Safety

TECALEMIT FMT 3
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44 1705 001GB-H FMT 3 meter 5
Appropriate use
The device may only be used if it is in perfect condition, and then only for its intended purpose, in
compliance with all safety regulations, with an awareness of the potential risks, and according to
the operating manual. Any faults that may impair the safety must be rectified immediately.
The device and its components are only to be used for handling the liquids listed and the purpose
described. Using the machine for any other purpose would constitute inappropriate use. The
manufacturer is not responsible for any loss arising as a result of this, the risk for this is borne only
by the operating company.
Organisational measures
This operating manual should always be kept readily available at the site of operation! Each person
concerned with the assembly, commissioning, maintenance and operation of the equipment must
have read and understood the entire operating manual. It is essential that the type plate and the
warning notices attached to the device are observed, and are maintained in a fully readable
condition.
Qualified personnel
The operating, maintenance and assembly personnel must be appropriately qualified for their work.
The areas of responsibility, competences and supervision of the personnel must be precisely
regulated by the operating company. If the personnel do not have the required knowledge, they
must be trained and instructed. The operating company must also ensure that the contents of the
operating manual are properly understood by the personnel.