TECE Uni - Throttle Set

4-10
Installation
To reduce the default large volume to . and the small
volume to . litres, the tank water level lever above the
filling valve must also be moved to the lowest mark on the
overflow.
Removing the drain valve
Totake outthe filling valve, open the splash guard with the
actuation block. Press the hold-down device downwards
as shown in the illustration and remove it from the tank.
Now pull the filling valve upwards out of the valve seat,
snap o the top part and take it out.
After removing the drain valve, the valve seat can be
removed by pulling it upwards.
Throttle set
If the flushing of a toilet ceramic is not adequate, the flush-
ing pressure can be reduced or increased with the help of
the throttle set.
The throttle set includes four dierent throttles:
• Blue: Diameter  mm (%)
• Grey: Diameter  mm (%)
• Black: Diameter  mm (%)
• White: Diameter  mm (%)
Reducing the flushing pressure
The throttle set can be used to reduce the flushing pres-
sure if water sprays out of the toilet ceramics To control the
flushing pressure, a throttle with a smaller internal diame-
ter can be used.
Increasing the flushing pressure
If the toilet ceramics are not being cleaned correctly, the
flushing pressure for  cm cisterns can be subsequently
increased. To increase the flushing pressure, install a throt-
tle with a larger internal diameter or remove the inserted
throttle.
The flush flow throttle can be easily installed in the valve
seat of the drain valve.
Ø 28 mmØ 29 mmØ 30 mmØ 32 mm