4-15
U 1 TECE urinal flush valve
Flushing time, factory setting s
Flushing time, setting range - s
Pre-flush, factory setting O
Pre-flush, setting range .- s
Pause function, factory setting O
Hygiene flush, factory setting O
Hygiene flush, setting range O, hours, hours
230 V/12 V mains version
The mains version is powered by a transformer that con-
verts the V alternating current to V direct current (
item number , please order separately).
The electronics has one connection to the transformer
(connector with white marking) and one to an electronic
cartridge (connector with black marking). The third cable
is used to earth the electronics on the flush valve's brass
housing.
Urinal electronics, 230 V/12 V mains version
Up to five urinal electronic units can be operated simul-
taneously with the transformer. For this reason, the
transformer is not (!) located in the flush valve's bare-wall
protection system. The transformer fits conveniently in a
standard flush-mounted installation box.
The electronics must be connected in parallel in a series
installation and the connection cable may be max. m
long between the connection at the transformer and the
most distant electronics.
Series installation of 5 urinal electronics, schematic diagram
It is recommended that only TECE original products are
used for the installation. Make sure that the polarity is cor-
rect when connecting the cables.
Technical data urinal infrared electronics, 230 V/12 V
mains
Minimum flow pressure . bar
Max. operating pressure bar
Flow rate at bar . l/s
Mains voltage V
Operating voltage V ( ± %)
Power input W
Max. power input W
Protection class III
Safety extra-low voltage
(SELV)
Flushing time, factory setting s
Flushing time, setting range - s
Pre-flush, factory setting O
Pre-flush, setting range .- s
Pause function, factory setting O
Hygiene flush, factory setting O
Hygiene flush, setting range O, hours, hours
To Next Page
Loading...
