TechBook in.touch 2 - LED Status Indicators; Home Module LED Status; Spa Module LED Status

9
LED Status
LED
Each in�touch 2 module has a status LED that can be used for troubleshooting purposes�
The LED is located on the top of both enclosures�
status LED status LED
* When the LED status is blinking (blue, green or red) this
indicates that the communication between the EN module and
the CO module it not established.
EN Module (home)
Pairing mode Yellow (Blinking)
Router not detected Red
Router detected Green
in�touch 2 server detected
Module is fully functional
Blue
CO Module (spa)
Pairing mode Yellow (Blinking)
Spa controller not detected Red
in�touch 2 server detected
Module is fully functional
Blue