13
Application
Select a spa
Home page
The main screen gives you access to your accessories, water temperature, water care and settings�
This page displays all the spas detected by your application.
To detect your spa, you need to connect your mobile device to the same
network to which you connected your in.touch 2-EN module.
Once you have done a connection with the spa its name will be saved on this
page to allow you to connect to this spa from anywhere�
The RF signal strength (communication between the two in�touch 2 modules)
is illustrated on the Select a spa page� There are 6 possibile states:
• Signal superior to 80%
• Signal between 80% and 51%
• Signal between 50% and 31%
• Signal below 30%
• The in�touch 2 CO (spa) module is not available
• The in�touch 2 EN (home) module is not available
To delete a spa from this list, slide the spa name to the left and tap on Delete�
Note: If you are currently connected on the same local network as your spa
and try to delete it, this one will reappear as soon as the menu refreshes�
Indicates the selected Water Care mode
Settings menu
Spa name
Message center that indicates status
of your spa: heating, filtration, error���
if you click on the message center
you will access the Spa state page
Water Care menu
Light toggle
Button to return to Select a spa
Indicates current spa water
temperature� Color varies according
to most important active state� Touch
to change set point
To Next Page
Loading...