6
Connection of the in.touch 2-CO (spa)
Simply connect the in�touch 2-CO module into an available CO port of the spa pack (or any other accessory with a free
CO port, such as the in�stream 2 audio amplifier, or the in�clear spa sanitizing system)�
Note that the in�touch 2-CO only has a single CO cable and thus must be installed at the end of the CO chain if more
than a single accessory is installed on the same CO port of the spa pack�
Note: Before powering up the spa pack again, please go to the next step and install the in�touch2-EN module�
Installation and connections
CO port
CO port
To Next Page
Loading...