16
Model: TX-178 Article No. 4973, 01/2022
Bluetooth
Choose Bluetooth mode from the Main menu and confirm with Enter.
Make sure that no other Bluetooth device is connected to the radio.
“Bluetooth Disconnected" will appear on the display.
Activate Bluetooth mode on the device that you want to connect. Look for
The radio on the list of detected devices on the Bluetooth device (refer to
the instruction manual of the device). Once the devices have found each
other, the radio will appear as “Technaxx TX-178“ on the Bluetooth device.
Select Technaxx TX-178 from the list. If you are required to enter a PIN
code, enter 0000 (four zeros). Certain devices may also require you to
approve the connection.
Once the connection has been successful, “Bluetooth Connected” will
appear on the display of the radio. Start playback on your Bluetooth device.
Control the playback from the Bluetooth device or from the TX-178 using
the Vol+/Vol- on the TX-178 and remote control. Adjust the volume both on
the Bluetooth device and the TX-178.
NOTE: Activate the Bluetooth feature on the phone and set the phone to
search for Bluetooth devices. Check the user guide of your phone for
instructions.
Auto reconnection:
When the TX-178 is in off state, switch it on and it will reconnect
automatically to the last connected device if it is reachable.
Further modes that could be enabled
You can enable the following modes to be seen in the Main menu by going
to Configuration→ Menu. Here you find the below disabled modes.
Local Radio
There is a shortcut Local Radio so that you can easily go to the station list
of your location.
The device can use the IP address to detect its current location and can
then automatically generate a list of local radio stations. However, you can
also enter a different country.
To Next Page
Loading...
Need help?
General