Technibike E-MTB - Page 38

34
• Pedals
(Vehicles with168/2013 approval).
* ABE: general type approval
Category 3
Components which may be replaced in consideration of the
conditions described below
• Pedals
(Incl. approved reectors, provided the pedal
is not wider than the series/original pedal (ve-
hicle with 2002/24/EC approval)).
• Tires
(As specied in vehicle documents, either in
accordance with ECE-R 75 or with approval of
tire manufacturer).
• Grips with screw clamps
(In this case, the vehicle width must not be
modied).
• Headset
• Bottom bracket
• Rear and front derailleur
(All gear change parts must be suitable for the
number of gears and compatible with one an-
other).
• Shift levers / Twist grip
(Provided that position on handlebars remains
unchanged).
• Cables and housings
• Chainwheels / Belt sprockets / Cassette
sprocket
(Provided that the number of teeth and the di-
ameter is identical to the series/original eld of
use).
• Chainguard
(Provided that it is free of sharp outer edges
and complies with the Delegated Regulation
No. 44/2014, Annex VIII).
• Mudguard
(Provided that it is free of sharp outer edges
and complies with the Delegated Regulation
No. 44/2014, Annex VIII). The clearance to the
tire, which should be 10mm at least, must also
be taken into account).
• Spokes
(Provided that the dimensions correspond to
the original part)
• Inner tube
(Provided that the design and the valve are
identical).
• Crank arm
(Provided that the length and the dimensions,
e.g. crank arms / frame centre (Q-Factor) are
observed).
• Chain / Toothed belt
(Provided that the original width is observed).
• Rim tape
(Rim tapes and rims must be compatible. Mod-
ied combinations may result in rim tape shift-
ing and thus in defective inner tubes).
• Saddle
(Provided that the offset to the rear does not
exceed 20mm with regard to the series / origi-
nal eld of use. Note that a modied load distri-
bution beyond the intended setting range may
possibly lead to critical steering properties.
The length of the saddle rails at the saddle
structure as well as the saddle form are also
important).
Category 4
Special notes for mounting accessories
• Additional battery/rechargeable battery-oper-
ated headlights are not permissible.
• Trailers are only permissible, if a trailer load is
entered under no. 17 of the certicate of con-
formity and a coupling device under no. 43.1.
Note: The maximum permissible trailer load
is 50 % of the tractor vehicle’s empty weight
(without batteries). There are only 50mm ball
coupling devices possible.
• Transporting children in a trailer is forbidden
in general!
• For safety reasons, it is strongly recommend-
ed not to mount child seats.
• Due to the undened load and load distribu-
tion, it is strongly recommended not to use
baskets.
• Bags without permanent attachment are con-
sidered cargo and permissible. (However, an
adequate load distribution must be observed
in this case).
• Topcases on the luggage carrier are permissi-
ble, provided that the luggage carrier’s bearing
load is observed.
Source: www.ziv-zweirad.de