Technica 100BASE-T1 SPY Mini - 2.1.3 RJ45 Ethernet Connectors

1000BASE-T1 SPY mini User Manual
10
Pin
Function
1
Digital Trigger Input / Output 1
2
Digital Trigger Input / Output 2
3
Signal Ground Reference
4
Signal Ground Reference
5
Signal Ground Reference
6
Digital Trigger Input / Output 3
7
Digital Trigger Input / Output 4
8
Digital Trigger Input / Output 5
9
Digital Trigger Input / Output 6
Table 2—3: Pinning information SubD9 Connector
Digital Trigger Output:
Digital Trigger Output Voltage is 3.3 Volt Level with a 4.7 KOhms pull-up resistor
Active Low. Drive Strength 20 mA
Digital Trigger Input:
Digital Trigger Input is a Voltage 3.3 Volt Level with a 4.7 KOhm pull-up resistor
Active LOW.
Note: The Trigger Connector has no function on firmware version 1.2.1.
2.1.3 RJ45 Ethernet connectors
There are two RJ45 Standard Ethernet connectors of the front side for Gigabit
Ethernet.
Depending on the selected Use Case they are forced to be 100 Mbit/s or Gigabit Ports.