1000BASE-T1 SPY mini User Manual
6 ADDITIONAL INFORMATION
• For the SPY mode -independent or combined-, the delay between two BroadR-
Reach ports is around 1.19µs. The delay is independent of the Ethernet packet
frame size.
• The SPY is especially built for testing AVB. For minimum delay the SPY must be
set to SPY Use Case. When using automotive AVB profile the time synchronization
is not influenced by the SPY.
• There is no special handling of AVB frames as this is not necessary.
• There is a problem on the device. Please, remove the power supply and restart the
board.
• Some Ethernet Adapters must have the VLAN & Packet Priority option disabled.
Please, change this configuration, going to Ethernet Adapter
Properties/Advanced/Packet Priority & VLAN. If this option is enabled, just
disabled. Otherwise, it should be enabled.
• No 100BASE-T1 support. Device is only for 1000BASE-T1 suitable
To Next Page
Loading...
