In some cases, e.g. when the AT&T Global Network Client is installed on the computer, or other
equipment between the computer and the DSL device, the wizard will not find the DSL device.
If the wizard didn't detect the DSL device, then go to paragraph 5.2 “Wizard did not detect the
Gateway”, page 24.
When the gateway has been found, the program will check it check it and verify it’s
configuration:
If a DSL device is found the setup wizard will try to find the type and the screen will look like
Illustration 4.14.
Sometimes the DSL device is protected by a password when the DSL device is used before.
Enter the correct user id and password to continue, or perform a factory reset as described in
par 5.5.1.
ATT_TG650s_Quick_Install_Guide Page 20
Illustration 4.14: Analyzing the gateways type and
configuration
Illustration 4.15: Enter the username and password
To Next Page
Loading...
Need help?
General
