The ports used are the yellow 4-port switch (port 1 supports GigabiEthernet) and the gray
DSL-port. The power socket is located next to the power switch on the right hand side on the
modem. The USB port is unused.
2.2
2.2
Generic firmware
Generic firmware
The TG650s as AT&T uses it runs standard generic firmware:
The default user is “Administrator”
Embedded templates
◦ Bridge mode; this is the only mode used and supported by AT&T.
◦ 3 router mode templates; unused
The configuration for specific countries will be done via external template files.
ATT_TG650s_Quick_Install_Guide Page 9
To Next Page
Loading...
