Technicolor TG650S

4.2.3
4.2.3
Finalizing the configuration
Finalizing the configuration
This ends the selection of configuration settings, and, the configuration you have created will
be pushed in to the Gateway.
This process can take some time, and possibly you will see a few reboots of the gateway. The
configuration becomes active during this phase. When all has been pushed in, the next panel
will appear:
After clocking “Finish” the configuration has been completed and the software will close.
ATT_TG650s_Quick_Install_Guide Page 23
Illustration 4.19: Pushing in the configuration.
Illustration 4.20: Configuration is complete.