Preparation
Connecting a Bluetooth® device
Preparation
•P la c e the Bluetooth® device within approx. 1 m (3 .3 ft) from the unit.
• Check the device operation using its operation instructions as required.
• Using the “Technics A udio Connect” app (free of charge) m akes connecting with Bluetooth® simple.
Pairing procedure - When pairing your headphones first time with a Bluetooth® device
1 In the power-off state, press and hold [ Í/l] of this unit for approx. 2 seconds until the
LED indicator lights for 1 second.
• The LED indicator will light alternately in blue and red.
Note: The LED indicator lights (Red/blue) to indicate that the unit is in pairing mode.
2 Turn on the power of the Bluetooth® device, and enable the Bluetooth® function.
3 Select “EAH-A800” from the Bluetooth® device's menu.
• A BD address (Bluetooth® Device address: an alphanumeric character
string that is displayed by and unique to the device) may be displayed
before “EAH -A800” is displayed.
• If prompted for a passkey, input the passkey “0000 (four zeros)” of this
unit.
• When the LED indicator blinks (blue)* twice at approximately 2 second
intervals, pairing has been completed and connection has been
established.
* The battery is low when it is blinking in red.
4 Confirm that this unit and the Bluetooth® device are connected.
Note
• If the connection with the device does not complete within 5 minutes, the pairing mode on this unit cancels and they
transition to connection standby mode. Perform pairing again.
• This unit rem embers the device lastly connected. The unit may connect automatically after turning on the power of
this unit.
e g .
13
To Next Page
Loading...
