27
(Continued)
Network setting from the setup menu
(when using Chromecast-enabled apps)
Using the “Google Home” app
“Wi-Fi Setup”
When using the Chromecast-enabled apps to play
music on this unit, you need to set up a network
connection using “Google Home” app. When the
network has been set up with another method, try
the setting again with the following procedure.
1 Press and hold [ ] (input source switch)
on the top while pressing [•DIMMER /
-INFO] on the rear of this unit.
• Connection methods (WPS/WPS PIN/Wi-Fi
Setup) are displayed in turn.
• The display changes every 5 seconds.
• If “Wi-Fi Setup” blinks after this unit is turned
on by pressing [
], press [ ] to hide the “Wi-
Fi Setup” screen and try the setting again.
Wi-Fi
Setup
• When using the “Google Home”
app to set up a connection
2 Release [ ] and [•DIMMER / -INFO]
while “Wi-Fi Setup” is displayed.
3 Start the app and follow the on-screen
instructions.
• When the connection is established, “Success”
is displayed.
“Fail” may be displayed if the connection was
not complete. Try this method again from the
setup menu. If “Fail” is still displayed, try other
methods.
4 Press [ ] to exit the setting.
Note
• This unit will be displayed as “Technics-
SC- C50 -
****
” if the device name is not set.
(“
****
” stands for characters unique to each set.)
• You can check your network information (SSID,
MAC address and IP address) from the “Google
Home” app or “Technics Audio Center” app.
• Some items on the “Google Home” app are
irrelevant to this unit.
To Next Page
Loading...
Need help?
General
