Technics RS-D225W - Page 11

lm DISASSEMBLY INSTRUCTIONS
How to remove the LED meter P.C.B.
and VR/SW P.C.B.
How to remove the cabinet
1. Remove the one screw (@).
2. Push the 3 tabs aside, and then
remove the LED P.C.B.
3. Remove the 2 screws (@, ®).
4. Push the 3 tabs aside, and then
remove the VR/SW P.C.B.
eRemove the 4 screws (@~@O).
Procedure
1-3
Cabinet
Tab
Eject Button
Fig. 1
How to remove the mechanism unit
1. Push the eject button (see fig. 1).
2. Remove the 6 screws (@~@).
3. Remove the counter belt (for
mechanism unit of tape [2)).
VR/SW P.C.B.
Counter [
Ref. No.
5
Procedure
1-5
How to remove the main P.C.B.
1. Remove the one screw (@).
2. Open the side of back chassis,
and then pull down the back
chassis.
. Push the 4 tabs aside.
¥ Serial Number Plate
* Serial No. Indication
¢ The serial number plate of the product is attached to the back chassis (shown in fig. 5).
—= ff