Technics RS-D225W - Adjust the Recording Level

Recording
Press, then insert the tape
cassette.
The side to be recorded facing
outward.
3 Power: “on” ( a— =)
Part where tape is exposed facing downward.
Technics
Steree Integra
‘Auto Space Control
Auto Tape Select
Press to stop Recording indicator
the recording.
6 Press.
Press.
(Recording stand-by mode)
(The recording indicator will be
illuminated.)
Press.
(Recording will begin.)
Press the
button to stop 5
the recording
temporarily.
source.
To record by using the remote-control.
unit
1. Press the “rec” button on the deck itself.
2. Press the “play” button on the remote-control unit.
To stop the recording temporarily:
Press the “stop” button on the remote-control unit.
(After about 4 seconds, the deck will automatically change to
the recording stand-by mode.)
To start the recording again, press the ‘‘play” button on the
remote-control unit.
Start the desired program
Note:
Only TAPE 2 can be used for recording. TAPE 1
has no record capability.
To make non-recorded spaces between tunes
With this unit, by following the steps below, it is possible to make
non-recorded spaces (four seconds long) between tunes.
ePress the edit-recording/auto space button.
(After about 4 seconds, the deck will automatically change to
the recording stand-by mode. To resume the recording, set the
button to the “‘off” position.)
1 Select the sound source.
Amplifier
(SU-Z990)
Tape deck
(RS-D225Ww)
Press to make non-
recorded spaces
between tunes.
“off”
(=~ 8)
“out” (=— —):
Tape recording without the
Dolby NR system.
“in”? (a> m=):
Tape recording with the
Dolby NR system.
9 Adjust the recording level.
When
the
recording
level
cannot
be
adjusted
The
recording
level
might
not
be
adjustable
when
the
stop
button
on
the
remote-control
transmitter
is
pressed.
If this happens, press the “play” button on the remote-
control transmitter.
Adjustment of the recording level
The numbers which you should use as a guide for the adjustment
of the tape level will differ depending upon the type of tape.
Normal Tape
CrO2 Tape
Metal Tape
+3dB