Technics RS-TR979 Operating Instructions

Recordings can be made first on side ‘‘A” and then side “B” of
the cassette in either tape deck 1 or tape deck 2. and then con¬
tinued to side "A” and side "B” of the cassette in the other tape
deck. This means, for example, if two 90-minute cassettes are us¬
ed, that a long recording (total length 3 hours) can be made.
1 Insert the cassettes to be used for recording
into deck 1 and deck 2.
Be sure that the forward-side indicators (» of both tape
decks are illuminated. (Press the forward-side playback but¬
ton, followed immediately by the stop button.)
2 Set the reverse mode selector to the “cx?”
position.
To record using the ATC function, now press the ATC button
on deck 2, and then, after the ATC settings have been com¬
pleted, press the ATC button on deck 1.
(See page 13.)
3 Press the record buttons of deck 1 and deck
2 .
(Both decks will then change to the recording stand-by
mode.)
4 Begin playback of the sound source and ad¬
just the recording level and the left/right
recording balance.
(Refer to steps 8 and 9 on page 12.)
After that, stop the play being done so as to adjust the
recording level.
5 Press the forward-side playback button ( ► )
of the first tape deck to be used for recor¬
ding, and then start playing the source to be
recorded from the beginning.
To stop the recording before it has finished, press the stop but¬
tons).
The same sound source can be recorded simultaneously to both
deck 1 and deck 2.
11 Insert the cassettes to be used for recording
into deck 1 and deck 2.
To avoid making the recording incorrectly, the same direc¬
tion of tape movement for recording should be selected for
each tape deck.
A Select the side(s) of the tape [one side only
(zr:) or both sides (cu>)j upon which the
recording is to be made.
To record using the ATC function, now press the ATC button
on deck 2, and then, after the ATC settings have been com¬
pleted, press the ATC button on deck 1.
(See page 13.)
3 Press the record buttons of deck 1 and deck
2 .
(Both decks will then change to the recording stand-by
mode.)
^ Begin playback of the sound source and ad¬
just the recording level and the left/right
recording balance.
(Refer to steps 8 and 9 on page 12.)
After that, stop the play being done so as to adjust the
recording level.
i) Press the playback buttons of deck 1 and
deck 2 at the same time, then start playing
the source to be recorded from the beginn¬
ing.
(Be sure that they are both for the same direction.)
Notes:
• If you selected recording on both-sides (c^D) In step 2, begin
recording from side A on both decks.
• Different sound sources cannot be recorded separately on
deck 1 and deck 2 at the same time.

Technics RS-TR979 Specifications

General

Brand	Technics
Model	RS-TR979
Category	Cassette Player
Language	English