Technics RS-TR979 Operating Instructions

After Recording
To prevent erasure of recorded
sounds
Remove the tab(s).
| To erase recorded sounds _|
When new recordings are made on a pre-recorded tape, all
sounds recorded on that portion of the tape are automatically
erased. To erase a tape without making a new recording, follow
the steps below.
1 Insert the recorded cassette into the
cassette holder of either deck (deck 2 for RS-
TR777).
2 Set the recording-level control to “0”.
■ To re-record on a protected cassette
Bluck up the hole by adhering a piece of cellophane tape to the
3 S et the reverse-mode selector to either one-
side only (— ) or both sides (cd).
area where the safety tab was broken out.
4 Set the Dolby noise-reduction button to OFF.
{The Dolby noise-reduction indicator will then switch OFF.)
5 Press the record button.
6 Press the playback button corresponding to
the side to be erased.
About the Quick-Reverse Function
[RS-TR979 only]
This is a function by which the unit detects the leader tape (the • In order to avoid an operational error at the beginning of the
transparent tape at both ends of the magnetic tape) and then tape, this function is not effective until about 15 seconds after
automatically reverses (in about one second) the direction of the playback (or recording) first starts.
tape during playback (or recording). • This function does not operate for tapes that do not have leader
tapes.
* This function may not function correctly:
If the leader tapes are colored.
If there is dirt or dust on the tape.
If the magnetic part of the tape Is thin.
If a strong light (direct sunlight, a spotlight, etc.) is shining into
the cassette holder.
When the unit is subjected to a strong impact.
• When the quick-reverse function is not activated, the tape’s
direction of movement will reverse when the tape reaches its
end.

Technics RS-TR979 Specifications

General

Brand	Technics
Model	RS-TR979
Category	Cassette Player
Language	English