Usetheremote control within 60 degrees and within 7 meters (23
ft.) facing directly toward the receiver's remote control signal
receptor.
J
I I
About 7 meters in front of the
sensor
(The actual range will depend on
the angle at which the remote
control is used.)
Operation notes
Aim the remote control's transmission window toward the unit's
sensor. Avoid any obstacles.
rm
Avoid dust Avoid dust
Be sure the transmission window and the unit's sensor are free
from dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another
strong light source strikes the receiving sensor of this unit. If
there is a problem, place the unit away from the light source.
When operating a TV, VCR or a CD changer (or CD player) with a
remote control sensor, face this remote control toward the
remote control sensor of the unit to be operated.
This remote control transmitter can be used to operate units
manufacturedby this companyother thanthis receiver unit, in-
cludingCD changers (or CD players),tape decks and alsoTVs
and VCRs manufacturedsince 1985.
Preparations before use
Check the appropriate connection of the power cords and con-
nection cables for the remote control in order to operate CD
changers (or CD players) and tape decks correctly. (See page 8
of the operating instructions for the main unit.)
If the connectionsare made as Shownonpage 8 and the power
supplyswitchesofeach unitare set toON, the power supplyfor
each unit willsimultaneouslyturn ON and OFF when the power
supplyof the receiveris turnedON and OFF.
When operating the CD changer (or CD player),"IV or VCR,
the remotecontrolsignalmayfail to operatethe unit,even ifit
is manufacturedby this company,because of the nature of
the remote control signal. In such cases, switch over the
remotecontrolsignalby the following method.
Depending on the model, there may be cases where opera-
tion is still not possible even if the remote control signal is
switched over due to differences in frequency range
characteristics.
For CD changer (or CD player) operation
Press POWER and CD simultaneously, hold
CD
for 2 seconds.
For TV operation
Press POWER and TV simultaneously, hold
TV
for 2 seconds.
For VCR operation
Press POWER and VCR simultaneously,
_ holdfor 2 seconds.
To restorethe previous memory contents, carry out the
same operationsone more time.
To Next Page
Loading...
Need help?
General
