Technics SA-GX910

et om
GOD
Ry
gi
© O10}
i
@QxO:
3 Begin the video
source to be
recorded.
Recording of video discs
Before recording, prepare the VCR 1 (or VCR 2) for recording.
Be sure to set the input selector on the VCR to the external input
position.
1 Select “VCR 1” (or “VCR 2”). 3 Begin the video source to be recorded.
(Refer to pages 58—60.)
2 Facing toward the VCR: Note:
Press these keys simultaneously. When recording from VCR to VCR, the operation must be done on
(Recording will begin.) a VCR and not on the remote control unit.
To stop recording temporarily
Facing toward the VCR: PAUSE
Select “VCR 1” (or “VCR 2”) by the function select a
keys (step 2 above) and then press the pause key.
Press again to start the recording.
To stop recording
Facing toward the VCR: sToP
Select “VCR 1” (or “VCR 2”) by the function select a
keys (step 2 above) and then press the stop key.
—57—