Timer operations
RQT5355
34
Using the timers
The play timer
This timer starts play of the selected source at the selected time. The
example shows settings for preset radio channel 8 to play between
6:30 and 7:40 at j40 dB.
Preparation: Turn the unit on, set the time (➡ page 11), preset
radio stations if you want the timer to start playing
the radio (➡ page 17).
1 1 Press [CLOCK/TIMER, –DEMO] to
select “FPLAY.”
Each time you press the button:
CLOCK>FPLAY>FREC>Original display
^-------------------------------------------------------------------}
2 Press [SET] within 3 seconds.
2–5
1 Press [TUNING (X or W)] to select
the condition required and
2 press [SET].
2 Select the start time.
3 Select the finish time.
4 Select the source.
TUNER()CD()TAPE
^----------------------------------J
Insert a CD or tape if you select these sources.
If you select TUNER
Select a preset channel.
5 Select the volume.
The play timer is now on standby. The display shows each
condition again then restores the original display.
6 Press [ê/I] to turn the unit off.
“FPLAY/FREC” indicator remains illuminated to show the
play (or record) timer is on even when ECO mode is selected
(➡ page 11).
The timer starts at the set time with the volume increasing gradually
to the set level.
To cancel the timer
Press [FPLAY/FREC] so “FPLAY” goes out.
Each time you press the button:
FPLAY>FREC>FPLAY FREC>Light off (OFF)
^---------------------------------------------------------------------------------}
The play timer function will be canceled, but the settings stay in the
memory.
For your reference:
When you insert cassettes in decks 1 and 2, deck 1 has priority.
2
3
4
5
1
6 1 2–5
1
2
1
2
œPLAY/œREC
SET
CLOCK/TIMER
@
DEMO
SET
6
FPLAY
FPLAY
FPLAY
FPLAY
FPLAY
2–5
?
TUNING
@
FPLAY
To Next Page
Loading...
Need help?
General
