Technics SE-CH610 - Speaker and AC Power Connections

SE-CH610
2, SB-CH610
iii Se
4 Connect the right (R) left (L) speaker cables. 5 Connect the AC power supply cord after you have
connected all other cables and cords.
If the power plug will not fit your socket, use the power plug
@Be sure to connect speaker cables before connecting the AC adaptor (included).
power supply cord.
®The load impedance of any speaker used with this unit must (To be continued)
be 6-80.
Connection of speaker cables EJ
1. Strip off the outer covering, and twist the center con-
ductor.
Make sure the bare ends of the wires are not unrav-
eled. (If they are, twist them tight again.)
. @ Tilt the lever back and insert the wire.
(@) Close the lever and pull the cord gently to be sure
that it is secured.
. Insert the wire to the rear panel of the amplifier, and
close the lever.
eTo prevent damage to circuitry, never short-circuit pos-
itive (+) and negative (—) speaker wires.
eBe sure to connect only positive (+) wires to positive
(+) terminals and negative (—) wires to negative (—)
terminals.