Operation & Maintenance Manual
CD-135 / CD-155
OM-02-02
Revision no.:
Revision date:
Chapter:
Issue:
Issue date:
Page:
Content:
02-OM-06-02
4
30.07.2014
57
74
7
20.07.2016
9. Remount the filter cap and tighten it to the specified
tightening torque.
Tightening Torque:
30 Nm
10. Loosen the oil filler screw and remove it. See Fig. 6.43.
11. Fill in the new gearbox oil according to the following details:
• DA42: 1.5 liters
• every other aircraft: 1.2 liters
12. Remount the oil filler screw with a new sealing ring and
tighten it to the specified tightening torque.
Tightening Torque:
35 Nm
13. Preset the proportional pressure reducing valve. Refer to
Chapter 72-10.16 of RM-02-02.
14. Secure the oil drain plug and the gearbox oil filter cap with
a locking wire. See Fig. 6.47.
CAUTION: Do not overfill the gearbox!
CAUTION: Use only gearbox oil which is specified in Chapter 3, Section
3.5, Page 3 of this Manual.
Note: Before refilling, shake the gearbox oil bottle, in order to mix the
gearbox oil and the additives.
Fig. 6.47 Lock wire between the oil drain plug and the filter cap
To Next Page
Loading...
Need help?
General
