Operation & Maintenance Manual
CD-135 / CD-155
OM-02-02
Chapter:
Issue:
Issue date:
Page:
Content:
02-OM-05-02
4
30.07.2014
2
8
Revision no.:
Revision date:
6
06.06.2016
5.1.2 Every 300 operating hours
• Inspect gearbox (refer to Chapter 6, Annex 15, Page 63 of
this Manual)
• Replace clutch, if clutch assy 05-7211-K006001 or
05-7211-K006002 is installed (refer to RM-02-02,
Chapter 72-10.02)
• Inspect fuel feed pump,
except 05-7312-K0073xx, 05-7312-K0133xx
(refer to Chapter 6, Annex 18, Page 71 of this Manual)
• Replace high-pressure pump
(refer to Chapter 6, Annex 11, Page 48 of this Manual)
5.1.3 Every 600 operating hours
• Replace alternator 14V
(refer to Chapter 6, Annex 12, Page 49 of this Manual)
• Replace alternator 28V
(refer to Chapter 6, Annex 12, Page 49 of this Manual)
• Replace high-pressure pump (refer to Chapter 6, Annex 11,
Page 48 of this Manual)
• Inspect fuel feed pump
05-7312-K0073xx, 05-7312-K0133xx
(refer to Chapter 6, Annex 18, Page 71 of this Manual)
• Replace rail pressure control valve
(refer to RM-02-02, Chapter 73-10.07)
• Inspect dual mass flywheel (refer to RM-02-02,
Chapter 05-20.02)
• Inspect gearbox (refer to Chapter 6, Annex 15, Page 63 of
this Manual)
Note: Replacement of the high-pressure pump at every 300 operating
hours is only applicable if TS-1 jet fuel is being used.
CAUTION: If TS-1 jet fuel is being used, the high-pressure pump MUST be
replaced every 300 operating hours.
CAUTION: The 600 hrs gearbox inspection interval is only valid in
combination with the dual mass flywheel and the use of gearbox
oil Shell Spirax S6 ATF ZM or CENTURION Gearbox Oil N1. In
all other cases, the interval remains at 300 hrs.
Expect gearboxes listed under Chapter 5.1.5.
To Next Page
Loading...
Need help?
General
