Operation & Maintenance Manual
CD-135 / CD-155
OM-02-02
Chapter:
Issue:
Issue date:
Page:
Content:
02-OM-01-02
4
30.07.2014
6
8
Revision no.:
Revision date:
-
-
1.13 Safety Information
• This engine is not suitable for aerobatic use.
• This engine is not approved for rotorcraft (helicopters,
gyrocopters, etc.).
• Never leave the aircraft unattended while the engine is
running.
• Secure all tools before starting the engine to prevent
personal injury or damage.
• When the engine is not in use, protect it and the fuel system
from contamination and accidental / unauthorized
manipulation.
• Never operate the engine without the specified quality and
quantity of fluids.
• Engine monitoring instruments are not included in the
scope of supply of the engine. Only use suitable, approved
instruments.
• In some areas, at some flight altitudes and under certain
operating conditions, it may be necessary to protect the
engine from extreme humidity, dust or sand using further
special equipment. Please consult the aircraft manufacturer
or distributor.
• Under extreme conditions such as low usage combined
with operation in a oceanic atmosphere, or in a very dusty
or sandy environment, shorter maintenance and inspection
intervals are recommended for your own safety.
• The Technify Motors GmbH engine must only be taken into
operation by persons who are familiar with the
corresponding manuals and who have the required level of
authorization.
WARNING:
Any Aircraft Engine Ground Run must be conducted in a secure
area that is protected from the unauthorized movement of
personnel!
Any rotating propeller is a potential safety hazard that can cause
severe personal injuries or even death!
Note: Technify Motors GmbH offers an engine display
P/N 02-7730-5501-()-() suitable to monitor all necessary engine
parameters.
This display is approved in accordance with JTSO-C113.
To Next Page
Loading...
Need help?
General
