TechniSat DIGITRADIO 3

68
7.2.4 Calling up DAB+ stations from a memory slot
> To call up a station that you have stored in the FAV memory slots, briefly press
the FAV buon and select a station slot (1...20) using the <, > buons. Press
the OK buon to play the station.
If no station is saved in the selected station slot, [(empty)] appears on the
display.
Alternatively, you can also use the relevant numeric key on the remote control
or the direct selection buon on the device.
7.2.5 Overwriting/deleting a station memory slot
> Simply save a new station in a favourite memory slot as described.
When calling up the factory seings all memory slots are deleted.
7.2.6 Signal strength
> Briefly press the MENU buon, use the < or > buons to select the [Display]
item and press the OK buon.
> Use the < or > buons to select the [Signal strength] item and press the OK
buon.
> Exit the menu by pressing the BACK buon several times.
> The display shows the signal strength in the form of a bar graph. The mark
shows the minimum signal strength.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in Section 5.3.3 if required.
7.2.7 Manual seing
This menu item is used to check the reception channels and can be used to align the
antenna.
> Briefly press the MENU buon, use the < or > buons to select the [Manual
seing] item and press the OK buon.
> Use the < or > and OK buons to select a channel (5A to 13F). The signal
intensity will now be shown in the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now
be aligned to the maximum signal intensity.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in Section 5.3.3 if required.
BDA_DIGITRADIO_3_V11.indd 68BDA_DIGITRADIO_3_V11.indd 68 10/11/2020 09:4510/11/2020 09:45