TechniSat DIGITRADIO 3

78
11.4 Repeat function
You can select whether a track, the entire folder/album or all of the tracks are to be
repeated.
> Press the Repeat buon multiple times.
The selected mode appears on the display (Repeat Track 1x, Repeat Album,
Repeat All).
> To switch the function o again, press the Repeat track buon as oen as
required until the [Repeat o] appears.
11.5 Random playback
With the random generator, the tracks can be played back in a randomly mixed
order.
> If you press the SHUFFLE buon while playing, Random appears on the
display.
> To switch the function o again, press the SHUFFLE buon again.
11.6 Programming function
With the programming function, you can play the tracks on a USB medium in an
order determined by you.
You can only undertake the programming if the device is in Stop Mode.
> Press the FAV buon on the remote control.
> The Folder Number and the Track Number flash on the display. [P01] appears
to the right of this. P01 is the first programming slot. Any tracks you want can
then be set up in sequence in the programming slots.
> Use the F+ and F- buons to select the folder where the track that you want
to put in Programme Location 1 is located.
> Use the Previous Track or Next Track to select the first track to be
programmed.
> Press the OK buon to accept the track.
> Programming slot 2 (P02) is then active. Proceed as described above to save
a track to programming slot 2. Do this to save the tracks you want to all the
programming slots.
> Press the Play/Pause buon to play the programmed tracks.
In order to add tracks to the current programming, press the Stop buon
once. You can then place additional tracks in the next unoccupied programme
location.
BDA_DIGITRADIO_3_V11.indd 78BDA_DIGITRADIO_3_V11.indd 78 10/11/2020 09:4510/11/2020 09:45