TechniSat DIGITRADIO 3

80
13.2 Alarm
The alarm switches the DIGITRADIO 3 on at the set time. 2 alarm times can be
programmed. The description of how to programme Alarm 1 serves as an example
13.2.1 Seing the alarm
> Press the Alarm 1/2 (31) buon on the remote control.
1 x press for configuration Alarm 1.
2 x press for configuration Alarm 2.
[Alarm 1 Seing] appears on the display.
> Press the OK buon to start configuring the seing.
> Use the P+ or P- buons to select [Alarm on] item and press the OK buon
to switch the alarm on.
If you want to switch o an already programmed alarm, select [Alarm O]
here.
> The display shows [Time 06:00], and the first character is flashing. You can
now enter the alarm time. First select the hours with the P+/P- buons and
press the OK buon to accept. Then enter the minutes. Accept this, again by
pressing the OK buon.
> Then enter the duration. Accept the input by pressing the OK buon.
> You then enter the source. BUZZER, DAB or FM are available. Press the OK
buon to accept the seing.
If you have selected DAB or FM, you can then enter whether or not you
want to be woken up by the last station listened to or by one from your
Favourites list.
> The next step is to set the repeat frequency. Here you can select from Daily
(every day of the week), Once, Weekdays (Mon. - Fri.) or Weekends (Sat. and
Sun.). Press the OK buon to apply the seing.
> Finally, you can then set the alarm volume using the P+/P- buons. Press the
OK buon to confirm. The alarm is then saved.
The time must be read for the alarm to function properly. For more details, see
Section 14.1.
A bell symbol appears on the display if the alarm is active and the DIGITRADIO
3 is in Standby mode.
BDA_DIGITRADIO_3_V11.indd 80BDA_DIGITRADIO_3_V11.indd 80 10/11/2020 09:4510/11/2020 09:45