Technogym Climb - Switching On and Off; Power Control and Isolation

Climb Excite
30
Switching on and o
To turn the the equipment on, switch the main switch to “I” (ON) position.
After a quick system check (reset), the equipment is ready for use.
To turn the equipment o, switch the main switch to “0” (OFF) position.
The equipment must be switched o only at the end of the exercise, when in standby.
If the equipment isn’t going to be used for a long time, as well as turning it o you should also
pull the plug out of the wall socket.
W
The switch is for turning the equipment on and o but does not isolate it
completely from the mains voltage, even in the “0” position (o). For complete
isolation you must unplug the power supply plug.