Technomark M4 inline - Pause Functionality; Crossing Point Definition

Page 25 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Modèle du 06/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
 Error code
 1st level
troubleshooting
 Remedial action
Error 58: TechnoLOG licence
error.
The necessary licence is not
present in the controller.
Contact the After-Sales
Customer Service Team.
Error 59: 16-channel line error.
Configuration issue for the file
line with regard to the 16
channels.
Check the configuration of the
16 channels.
Contact the After-Sales
Customer Service Team.
Error 64: 16-channel card error.
Card not detected.
Contact the After-Sales
Customer Service Team.
Error 65: Error in the IDI
calibration function.
The stylus/part distances have
not been respected.
The stylus is stuck in the striker
unit.
Check stylus/part distances.
Check the condition of the
striker unit + stylus, clean and
lubricate the stylus.
Restart an IDI calibration,
checking that this is the only
menu open.
Error 66: Broken stylus error.
The IDI Track function has
detected that the stylus is
broken.
Replace the stylus.
Error 67: Part positioning error.
The stylus/part distance is
outside the specifications
configured in the controller.
Check stylus/part distance.
Error 68: Variable empty.
The variable, set as forced, is
empty when the marking is
initiated.
Check that the value of the
variable has been correctly sent
to the controller by the master
system.
Check that the settings of the
variable match the information
sent.