-12-
AUDIO OPERATIONS
Note :
The following points apply throughout the “AUDIO and
VIDEO OPERATIONS” sections unless otherwise noted.
To simplify explanations, instructions refer to names
of buttons and controls on the front panel, making no
mention of the use of remote control unit.
To listen to a source other than TAPE 2 (tape deck),
press the TAPE 2 MONITOR button to the OFF
position (the TAPE monitor indicator will not light
in the display).
Private listening
For private listening, insert the headphones (1/4-inch
plug) into the PHONES jack.
MUTING Button (on the Remote Control Unit)
Press this to mute the sound from the speakers and
headphones when answering the telephone, etc.
To restore the original volume, press the MUTING button
again. While muting is engaged, the MUTING indicator
will flicker.
Sleep Timer Operation
SLEEP Timer Function
This function allows you to preprogram the receiver
to switch its own power off automatically.
You can then enjoy the audio/video system for a
specified amount of time without having to worry
about turning the unit off later.
Each press of the SLEEP button changes the time
indication by 10 minutes.
SLEEP 90 SLEEP 80 • • • SLEEP 10
(Released condition)
To let the remaining time (until power off) appear on
the display while the sleep timer is engaged, press
the SLEEP button once.
M
Basic Operations
1. Press the POWER button ON.
2. Set the BASS BOOST switch to the OFF position.
3. Adjust the tone as required with the BASS and TREBLE
tone controls. Adjust the balance between the left and
right channels with the BALANCE control.
4. Select the desired source with the FUNCTION
(source) selector. (The FUNCTION indicator will light.)
5. Select the desired surround mode with the
SURROUND MODE buttons. (The SURROUND indicator
lights in the display.)
6. Select the speaker system to be used with the
SPEAKERS select buttons.
With the unit in the STEREO mode, speakers “A” and
“B” can be selected simultaneously.
If the unit is to be operated in any of the surround
modes, speaker selection is automatically limited
to SPEAKERS A only.
7. Start playing the source component.
8. Gradually turn up the volume to the required level
with the MASTER VOLUME control.
To Next Page
Loading...
Need help?
General
