- 28 -
REMOTE CONTROL UNIT
Using the Remote Control Unit
By using the provided remote control unit, the receiver
and some other components including DVDC96, DVDC 95,
CDC 86, CDC 85 and TDX 85 can be controlled from your
listening position.
To use the remote control unit, point it at the REMOTE
SENSOR window of the receiver (or other component).
REMOTE SENSOR window
of the receiver or other
component
Notes :
Even if the remote control unit is operated within the
effective range, remote control operation may be
impossible if there are any obstacles between the
unit and the remote control.
If the remote control unit is operated near
other appliances which generate infrared rays, or if
other remote control devices using infrared rays are
used near the unit, it may operate incorrectly.
Conversely, the other appliances may also operate
incorrectly.
1. Remove the battery compartment cover.
2. Insert two “AAA” (R03, UM-4) dry batteries.
Make sure that the batteries are inserted with their
positive and negative poles positioned correctly.
3. Close the cover until it clicks.
Battery Replacement
If the distance required between the remote control unit
and main unit decreases, the batteries are exhausted. In
this case replace the batteries with new ones.
Precautions concerning batteries
Be sure to insert the batteries with correct positive
“ “ and negative “ “ polarities.
Use batteries of the same type. Never use different
types of batteries together.
Rechargeable and non-rechargeable batteries can be
used. Refer to the precautions on their labels.
When the remote control unit is not to be used for a
long time (more than a month), remove the batteries
from the remote control unit to prevent them from
leaking. If they leak, wipe away the liquid inside the
battery compartment and replace the batteries with
new ones.
Do not heat or disassemble batteries and never
dispose of old batteries by throwing them in a fire.
Battery Installation
+
_
+
_
To Next Page
Loading...
Need help?
General
