TECO F510 series - Chapter 3 Programming Functions

10
Chapter 3 Programming Functions
Parameter
Group
Name
Group 00 Basic Parameters
Group 01 V/F Control Parameters
Group 02 IM Motor Parameters
Group 03 External Digital Input and Output Parameters
Group 04 External Analog Input and Output Parameters
Group 05 Multi-Speed Parameters
Group 06 Automatic Program Operation Parameters
Group 07 Start/ Stop Parameters
Group 08 Protection Parameters
Group 09 Communication Parameters
Group 10 PID Parameters
Group 11 Auxiliary Parameters
Group 12 Monitoring Parameters
Group 13 Maintenance Parameters
Group 14 PLC Setting Parameters
Group 15 PLC Monitoring Parameters
Group 16 LCD Parameters
Group 17 IM Motor Automatic Tuning Parameters
Group 18 Slip Compensation Parameters
Group 19 Reserved
Group 20 Speed Control Parameters
Group 21 Torque Control Parameters
Group 22 PM Motor Parameters
Group 23 Pump & HVAC
Group 24 1 to 8 Pump Card Function Group
Parameter Attribute
*1
Parameters can be changed during
run operation.
Note1: New added or modified parameters in
software V1.41
Note2: New added or modified parameters in
software V1.43
Note3: New added or modified parameters in
software V1.50
Note4: New added or modified parameters in
software V1.51
Note5: New added or modified parameters in
software V1.52
Note6: New added or modified parameters in
software V1.53
*2
Read-only parameters for
communication.
*3
Parameter will not reset to default
during a factory reset
*4 Read-only parameter
*5
Only displayed in using LED
keypad
*6
*7
Modified(*6) and New added (*7)
parameters in software V1.4
*8
The value will be modified depend
on the setting of 13-08