TECO JSDE Series User Manual

1
■Warning and Alert:
Warning
y Do not proceed to the assembly of the line while electrifying.
y Before doing any maintenance or repair always wait until CHARGE LED goes off and supply
power is totally separation from the drive.
y The output terminal of Servo drive [U, V, W] must NOT touch the AC power.
Alert
y Install the cooling fan for the Servo drive while the environment temperature is too high.
Ex. Servo driver is installed in the control panel.
y Do not proceed to the Anti-Pressure-Test to the Servo driver.
y Confirm the quick stop function is available before operate servo drive.
y Matching up machine to change the user parameter setting before machine performs. If there is
no according correct setting number, it could lead to out of control or breakdown.
Safety proceeding:
Check the covering letter detail before installing, running, maintaining and examining. Furthermore, only
the profession-technician can proceed to assemble and repair.
Safety proceeding in the covering letter discriminate between “Warning” & ”Alert”.
Indicating the possibility dangerous situation. It could cause the death or serious
damage if being ignored.
Indicating the possibility dangerous situation. It could cause smaller or lighter human
injured and damage of equipment.
Read this covering letter detail before using Servo driver.
Alarm
Warning
!
!

TECO JSDE Series Specifications

General

Current Rating	Varies by model
Feedback	Tachometer Feedback
Protection	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Operating Temperature	0°C to 40°C (32°F to 104°F)
Power Rating	Varies by model

Summary

Safety Warnings and Alerts

Electrical Warning for Operation and Maintenance

Do not proceed with assembly while electrifying, wait for charge LED off for maintenance.

Environmental Alert for Servo Drive Operation

Install cooling fan, avoid anti-pressure test, confirm quick stop function.

Safety Proceeding and Symbol Meanings

Chapter 1: Checking and Installing

Product Checking and Model Designation

Verifies products and explains model designation codes for drives and motors.

Drive Installation Conditions

Servomotor Installation Conditions

Chapter 2: Wiring

Main Circuit and Peripheral Wiring

Wiring for main circuit, peripheral devices, and motor connections.

Wiring Rules, Specifications, and Terminals

Guidelines for wire material, cable length, specs, and terminal layouts for drives, motors, encoders.

I/O, Communication, and Encoder Terminals

Typical Circuit Wiring Examples

Chapter 5: Troubleshooting

Alarm Functions Overview

Explains alarm display format, alarm codes, and basic alarm reset methods.

Alarm and Warning Troubleshooting Guide

Lists alarm codes, descriptions, corrective actions, and reset methods for troubleshooting.