Chapter 1: Getting Started 5
Connect Programming Cable
Remove the plastic connector cover from the SG2 using a flathead screwdriver as shown in the figure below.
Plug in the plastic connector end of the programming cable into the SG2 smart relay as shown in the figure below.
Connect the opposite end of the cable to an RS232 serial port or USB port on the computer.
Establish Communication
a. Open the SG2 Client software and select “New L
AD” as shown below left.
b. Select “Operation/Link Com Port…” as shown below right.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
