Chapter 2 Installation 18
Wiring
WARNING: The I/O signal cables should not be routed parallel to the power cable, or in the same cable trays
to avoid the signal interference.
To avoid a short circuit on the load side, it is recommended to connect a fuse between each output terminals
and loads.
Wire size and Terminal Torque
Input 12/24V DC
Input 100~240V /24V AC
26...1626...1426...1426...1826...16
AWG
3.5
(0.14in)
lb-in
Nm
0.6
5.4
0.14...1.5
mm
2
0.14...1.50.14...2.50.14...0.75 0.14...2.5
C
C
10/12 POINTS 20 POINTS
+
-
A1 A2
-
+
A2
A1
A3
A4
12 POINTS 20 POINTS
A1 A3A2 A4
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
