Chapter 3 Program Tools 33
① Press “SEL” to display cursor
② Press “↑”, “↓”, “←”, “→” to move cursor
③ Press “SEL” again to choice modified position
④ Press “↑”, “↓” to change number and press “←”, “→” to move cursor
⑤ Press “OK” to make sure the modify value
Press “←” (Z02) to disable H03 coil, and the LCD display changes to initial
frame.
Press “↓”(Z03) to reset Timer (T01、T02、T03) as program designed.
Program Documentation
The SG2 Client software includes the ability to document a program using Symbols and Line Comments.
Symbols are used to label each I/O address up to a length of 12 characters. Line Comments are used to document
sections of a program. Each Line Comment can have up to 4 lines with each line containing up to 50 characters in
length. Below are examples of entering Symbols and Line Comments.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
