TECO SG2-10HR-A - Appendix A: Keypad Programming in Ladder Mode

Appendix: Keypad Programming 243
Appendix A: Keypad programming in Ladder mode
Operation Sample:
1234567 8 Column
Line 1 >LADDER
2FUN.BLOCK
3 PARAMETER
4RUN
Procedure 1: 1 2 3 4 5 6 7 8 Column
Press ‘OK’ Line 1
2
Enter LADDER Edition 3
4
Procedure 2 : 1 2 3 4 5 6 7 8 Column
Press ‘SEL’ Line 1 I01
2
(When cursor located at character or 3
digital, press the button to show I01) 4
Procedure 3 : 1 2 3 4 5 6 7 8 Column
Press ‘↑’ 3 times
Line 1 Q0 1
2
3
4
(Press ‘↑ ↓’, and the digital cursor
located will change from I to G).
Procedure 4 : 1 2 3 4 5 6 7 8 Column
Press ‘SEL’ Line 1 q01
2
(start /end modifying parameter) 3
4
Procedure 5 : 1 2 3 4 5 6 7 8 Column
Press ‘→’ 2 times
Line 1 q 0 1
2
(Press ‘← →’,
3
the cursor located in digital) 4
Procedure 6 : 1 2 3 4 5 6 7 8 Column
Press ‘↑’ for 3 times
Line 1 q 0 4
2
(Press ‘↑ ↓’,
3
the digital the cursor located will 4
change from 1 to 4)
Procedure 7 :
1234567 8 Column
Press ‘←’ 2 times
Line 1 q04
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor