Chapter 9 Expansion Module 239
4. Click the Search icon and choose it.
5. Click the Ping icon
→ Ping button. The results display in the Status area, make sure the unit is properly
attached to the network and that the IP address assigned is valid for the particular network segment you are working
with. Click the Close button.
6. Click the Ports. Rework the Baud Rate member, Data Bits member, Stop Bits member. But make sure these
members accord with the Main type module. Write down the Local Port member: 10001. When you are finished
then click OK. Click the Update Settings button to save your settings.
Note1: We recommend Baud Rate: 19200bps; Data Bits: 8; Stop Bits: 1; Parity bit: no parity.
Note2: When you click the Update Settings button to save your settings, the “status: online” will turn to “status:
busy”; Waiting for about 5 Sec. the “status: busy” will turn to “status: online”. After this you are configuring
successful.
Click Ports
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
