Turn on the device, then quick press the [ FM ], [ MW/LW ], [ SW + ] or [ SW - ] button to select your desired
frequency band. You can tune into your favorite stations using any of the following tuning methods.
Manual Tuning
In VF mode, rotate the [ TUNING ] and [ FINE TUNING ] knobs to search for your desired stations.
Auto Scan
In VF mode, press and hold the [ VF/VM ] button. The device will automatically scan the entire frequency band
for available stations. When a station is found it will stay there for about 5 seconds before continuing the search.
To stop the auto scan feature, quick press the [ VF/VM ] button or gently rotate the [ TUNING ] knob.
Direct Keypad Entry
In VF mode, quick press the numeric keys [ 0 - 9 ] (followed by [ ]) to directly enter a station frequency.
Notes:
For FM band, ignore the decimal point when inputting frequency numbers. For example: enter 8, 9, 3 for
FM 89.3 MHz.
If the entered frequency is not within the covering range, the error “ Err ” symbol will be displayed
SW / SSB Meter Band Selection
When tuned into a shortwave or SSB frequency, quick press [ SW + ] or [ SW - ] to change the SW or SSB
meter band:
SW meter bands: 120m / 90m / 75m / 60m / 49m / 41m / 31m / 25m / 22m / 19m / 16m / 15m / 13m / 11m
SSB meter bands: 160m / 80m / 60m / 40m / 30m / 24m / 20m / 17m / 15m / 12m / 10m
TUNING INTO STATIONS
10
To Next Page
Loading...