LISTENING TO STORED STATIONS
When recalling stored stations or initiating a memory page scan, Page 0 (P0) only shows the stations of the
frequency band (FM/LW/MW/SW) or mode (SYNC/SSB) that was selected when entering the memory (VM).
In Page 1-24 it is not necessary to preselect a frequency band or mode, the device will show stored stations
from all bands within the selected memory page.
Recalling Stored Stations
Operation for memory Page 0:
1) Use the [ PAGE - ] or [ PAGE + ] button to select memory page P0.
2) Select a frequency band (FM, LW, MW, SW) or mode (SYNC, SSB).
3) Quick press the [ VF/VM ] button to enter the VM mode (see also page 8).
4) Rotate the [ TUNING ] knob with some vigor to browse through the station list, or use the numeric keys to
directly enter the preset station number.
Operation for memory Page 1-24:
1) Use the [ PAGE - ] or [ PAGE + ] button to select a memory page.
2) Rotate the [ TUNING ] knob with some vigor to browse through the selected memory page, or use the
numeric keys to directly enter the preset station number.
Memory Page Scan
This device can auto scan all stored stations within a memory page, staying on each station for about 5 seconds.
1) Use the [ PAGE - ] or [ PAGE + ] button to select a memory page.
2) Press and hold the [ VF/VM ] button until “PRESET” flashes in the upper right corner of the display. The
device starts to scan all stored stations within the selected memory page.
3) To stop scanning, quick press the [ VF/VM ] button or gently rotate the [ TUNING ] knob.
13
To Next Page
Loading...
Need help?
General