FM Stereo/Mono Selection
While listening to FM, quick press [ FM ]. If the FM signal is in stereo the “ ” icon is shown on the display.
Quick press [ FM ] again to return to mono listening.
Note: When the FM signal is broadcasted in mono, or if the station is broadcasted in stereo but the signal is
weak, “ ” is not displayed.
Display Mode
When listening to the radio, quick press [ DISPLAY/SNOOZE ] repeatedly to select your preferred display mode.
The top right corner of the display can show the signal strength/signal-to-noise ratio, alarm time “Timer A”,
alarm time “Timer B”, clock time, or the memory location of the frequency (in VM mode only).
16
Play/Pause: Quick press [ ]
Restart track: Quick press [ ]
Previous: Quick press [ ] twice, or rotate the [ TUNING ] knob
downwards.
Next: Quick press [ ], or rotate the [ TUNING ] knob upwards.
(2) AUDIO PLAYER MODE
Insert a microSD card with supported audio files into the card slot at the
bottom of the device. Turn the device on. If in radio mode, quick press
[ MODE ] (RADIO / MP3) to enter the audio player mode.
The display shows “ ” and “ ” and audio playback starts
automatically.
Notes:
Supported audio formats: 16bit / 44.1kHz, FLAC / WAV / APE / WMA and MP3.
“ ” is displayed when there is no card inserted, the card is not supported,
or the card does not contain any (supported) files.
track number
repeat track icon
playback status
- running during playback
- “ “ while paused
playback display
To Next Page
Loading...
