Deleting Stations During Memory Page Scan
This device can auto scan all stored stations within a memory page, staying on each station for about 5
seconds, and giving you the opportunity to delete any unwanted stations.
1) Use the [ PAGE - ] or [ PAGE + ] button to select the memory page from which to delete stored stations.
2) Press and hold the [ VF/VM ] button to start the memory scan.
3) Upon finding an unwanted station, press the [ DEL. ] button. No confirmation is required and scanning
continues immediately.
4) To stop the memory scan, quick press the [ VF/VM ] button or gently rotate the [ TUNING ] knob.
Deleting All Stored Stations
To delete all stations within a memory page:
1) Select the memory page from which you wish to delete all stored stations.
2) Press and hold the [ DEL. ] button until “dEL” and “PAGE” flash on the display.
3) Quick press the [ DEL. ] button again to confirm.
Note: In Page 0, stored stations need to be deleted for each frequency band or
mode (SYNC/SSB) separately.
To delete all stations from the memory:
1) Turn the device off.
2) Press and hold [ DEL. ] untill “dEL” and “ALL” flash on the display.
3) Quick press the red (POWER/SLEEP) button to confirm and delete all stored stations.
Note: If the red (POWER/SLEEP) button is not pressed for confirmation within 3 seconds, the delete function is
exited automatically.
DELETING STORED STATIONS
Deleting a Single Station
1) Enter the memory (VM) mode and select the station that you wish to delete.
2) Press and hold the [ DEL. ] button until “dEL” and “PRESET” flash on the
display.
3) Quick press the [ DEL. ] button to delete the unwanted station.
Note: If the [ DEL. ] button is not pressed for confirmation within 3 seconds,
the delete function is exited automatically.
14
PAGE
PRESET
PAGE
PRESET
To Next Page
Loading...