18
(3) COMPUTER SPEAKER MODE
You can use this device as a speaker for a computer by following the below steps:
1) Turn on the device and quick press [ MODE ] to enter the audio player mode.
2) Connect the digital audio input socket (micro-USB type-B) on the left side of this device to the computer
using a suitable USB data cable.
3) Turn on the audio player of the computer.
Note:
If there is no sound, adjust the sound output settings of your computer, or turn off and restart the computer’s
audio player.
You can use the [ ], [ ] and [ ] buttons to control audio playback, and use the [ VOLUME ],
[ TREBLE ] and [ BASS ] knobs to adjust the audio output.
(4) OTHER SETTINGS AND FEATURES
Activating/Deactivating the Alarm
There are two independently programmable alarms to turn on the device at a specific time. Quick press
[ TIMER A ] or [ TIMER B ] to activate the alarm. The alarm “ ” icon is shown on the display to indicate that
the device will turn on at the preset time. Quick press again to deactivate the alarm setting.
Setting the Alarm Time
1) With the device off, press and hold [ TIMER A ], the alarm time in the upper right corner of the display will
start to flash.
2) While still flashing, use the numeric keys to enter the time (4 digits in total). Alternatively, rotate the
[ TUNING ] knob to adjust the hour and the [ FINE TUNING ] knob to adjust the minutes, followed by [ ]
to confirm. The duration of the alarm now flashes on the display.
3) While still flashing, rotate the [ TUNING ] knob to set the duration after which the device turns off (01 -
60 minutes).
4) Quick press [ TIMER A ] to confirm the setting. The alarm “ ” icon is shown on the display. For setting
[ TIMER B ] you can follow the same steps.
To Next Page
Loading...
Need help?
General