TED 1001 - Part II Safety Precautions

To Next Page

To Previous Page

Page 6

P A R T I I – S A F E T Y

Every effort has been made in providing for the safe, secure installation of TED. The instal-

lation of TED requires the cover of the main electrical circuit breaker panel to be removed.

When this is done, there exists the potential hazard of shock, burn, or even electrocution.

Do not attempt to complete this installation unless you are very familiar with the electri-

cal components and operation of the circuit breaker panel. Even when the Main Circuit

Breaker has been turned to the “OFF” position, there may still be areas within the circuit

breaker panel that may be electried. Do not attempt installation unless you know where

these areas are.

WARNING - These servicing instructions are for use by Qualied Personnel only. To reduce

the risk of electric shock, DO NOT perform any servicing other than that contained in these

operational instructions, unless you are qualied to do so.

WARNING - The MTU must be connected to a switch or circuit breaker in close proximity

to the equipment and within easy reach of the operator. It must be marked as the discon-

necting device for the MTU.

WARNING - If the equipment is used in a manner not specied in these instruction, the

protection provided by the equipment may be impaired.

This symbol will be found throughout the in-

structions where there is a potential for elec-

tric shock, burn, or even electrocution. Do not

attempt to complete the noted section if you

are not an electrician, or qualied installer.

Model 1001 / Model 1002

TESTED TO COMPLY WITH

FCC STANDARDS

FOR HOME AND OFFICE USE

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any interference received,

including interference that may cause undesired operations.