TEKTROL Tek-Flux 1400A Series User Manual

Technology Solutions
Instruction Manual
Tek-Flux 1400A
www.tek-trol.com
14
• Install flow meter at the rising pipe
• For installing at open pipe, flow meter should be installed at relative low. If the fall in
the pipe is more than 5m, vent valve should be installed at the sensor downstream
where it should have back pressure
• Control valve and stop valve should be installed at the downstream of sensor and not
at the upstream side.
• Sensor should be installed at the outlet of pump and not at the inlet

TEKTROL Tek-Flux 1400A Series Specifications

General

Brand	TEKTROL
Model	Tek-Flux 1400A Series
Category	Measuring Instruments
Language	English